Removal and Installation of the Torque Rod Bushings

Attention! Due to the structural diversity of the mounting of shock absorbers to the suspension and the body of the car, only the general principles of the bushings replacement are considered in this manual.

Dismantling

  1. Unscrew the elements of the torque rod mounting to the suspension and the body of the car.
  2. Remove the thrust washers.
  3. Remove the torque rod from the car.
  4. Remove the worn bushings by any suitable way.
  5. Remove the metal spacers, if any, applied to the torque rod.
  6. Clean the thrust washers and spacers from rust and dirt. Rate the degree of wear and damage to these elements. Replace if necessary.
  7. Clean the bushings bearings on the torque rod, body and suspension.

sb19

Installation

  1. Compare the diameters of the bearings, thrust washers, spacer and new bushings. Make sure of right choice of the bushings.
  2. Lubricate the new bushings, spacers, bearings on the torque bar with the grease supplied in the kit, or any other consistent grease.
  3. Install new bushings in bearings.
  4. Install the spacers.
  5. Install the torque rod in the car.
  6. Install thrust washers and fix torque rod to the body and car’s suspension
  7. Check the evenness of bushings placement in the bearings.

Attention! The tightening of the fixing bolts must be performed on the loaded suspension, when car stands on wheels on the plain surface. Tightening force is according to the manufacturer’s recommendations.

sb8